We have developed a 64-neuron electrically trainable BiCMOS analog neuroprocessor based on 3-layered PDP networks with a feedforward time as short as 10 µs which is equivalent to the operation speed as high as 108 multiplications per second. A crucial point in this development is application of a dynamic refreshment technique to a weighting circuit. A sufficiently long retention time of the synapse weight has thereby been attained, leading to a practical operation of the neuroprocessor.

This paper describes the design of a high-speed 4-2 compressor for fast multipliers. Through the survey of the six kinds of representative conventional 4-2 compressor (RBA 1-3 and NBA 1-3) in both the redundant binary (RB) and the normal binary (NB) scheme, we extracted two problems that degrades the operating speed. The first is the use of multi-input complex gates and the second is the existence of transmission gates (TG) at the input and/or output stages. To solve these problems, we propose high-speed 4-2 compressors using the RB scheme, which we call the high-speed redundant binary adders (HSRBAs). Six kinds of HSRBAs, HSRBA 1-6, were derived by making the Boolean equations suitable for high-speed CMOS circuits. Among them, HSRBA2, HSRBA4 and HSRBA6 have no multi-input complex gate and input/output TG, and perform at a delay time of 0.89 ns which is the fastest of all 4-2 compressors. We investigated the logical relation between HSRBAs and conventional 4-2 compressors by analyzing the Boolean equations for each circuit. This investigation shows that all the conventional redundant binary adders RBA1-3 have the same logic structures as HSRBA2. We also showed the conventional normal binary adders NBA1-3 have the same logic structures as HSRBA1, HSRBA3 and HSRBA5, respectively. This implies all 4-2 compressors can be derived from the same equation regardless of RB or NB. We applied the HSRBA2 to a 5454-bit multiplier using 0.5-µm CMOS technology. The multiplication time at the supply voltage of 3.3 V was 8.8 ns. This is the fastest 5454-bit multiplier with 0.5-µm CMOS so far, and 83% of the speed improvement is due to the high speed 4-2 compressor.

A striped inductor and its utilization of a voltage-controlled oscillator (VCO) are studied with the aim of suppressing phase noise degradation in K- and Ka-bands. The proposed striped inductor exhibits reduced series resistance in the high frequency region by increasing the cross-sectional peripheral length, as with the Litz wire, and the VCO of the striped inductor simultaneously exhibits a lower phase noise than that of the conventional inductor. Striped and conventional inductors and VCOs are designed and fabricated, and their use of K- and Ka-bands is measured. Results show that the Q factor and corner frequency of the striped inductor are approximately 1.3 and 1.6 times higher, respectively, than that of the conventional inductor. Moreover, the 1-MHz-offset phase noise of the striped inductor's VCO in the K- and Ka-bands was approximately 3.5 dB lower than that of the conventional inductor. In this study, a 65-nm standard CMOS process was used.

System capacity of a wireless system can be improved greatly by using variable rate transmission. Assuming a low-rate and wide-coverage signaling-only wireless network, in this paper we evaluate, analytically and numerically, the extent of this improvement for various schemes with variable transmission rates. We considered log-normal shadowing as well as the effect of Rayleigh fading. Simulation results show close proximity with the analytical predictions.

A third order harmonic oscillator has been proposed based on the resonant tunneling diode pair oscillators. This oscillator has significant advantages, good stability of the oscillation frequency against the load impedance change together with capability to output higher frequencies. Proper circuit operation has been demonstrated using circuit simulations. It has been also shown that the output frequency is stable against the load impedance change.